Sections and stages of hazardous waste in CPU thermal

Pass the burning of hazardous waste in the unit within three consecutive sections integrated with each other are as follows: 
1 - rotary kiln with secondary burning chamber 
(After chamber kiln with Rotary) INCINERATION 
  2 - Department of steam condensation 
  ((waste heat boiler for steam generation HEAT RECOVERY 
3 - Operations Section washing and cleaning and purification of gases 
(Multi-stage flue gas cleaning) FLUE GAS CLEANING 
1 - rotary kiln and specifications. 
** Total length of inner cylinder rotary kiln (12 meters). 
** Qtaralasitoana an internal rotary kiln (5.3 meters). 
* The inner cylinder rotary kiln diagonal from the center or sight B (57.1) degrees. A rate (3%) 
** Total number of cycles of the inner cylinder of the rotary kiln (5.0 to 3) cycle per minute. 
* You can rotary kiln as a result of combustion processes that converts tons (1) One of the hazardous waste to (10-15%) of non-hazardous solid waste, which is similar to asphalt. And (85-90%) of the gases emitted. 
* Rotary kiln has the ability to burn 80 tons of hazardous waste per day. 
* Rotary kiln has the ability to burn (80,000) tons of hazardous waste annually. 
** Components involved in the manufacture of rotary kiln, is stainless steel to high temperatures, and also stainless steel chemical reactions that occur as a result of oxidation reactions. 
** Works rotary kiln at high temperatures that reach between (1000 - 1200) degree Maoist. Secondary burning chamber is located to the right and the direction perpendicular to the top and immediately after the rotary kiln. Designed as a secondary burning chamber similar to the composition of the internal composition of the rotary kiln where resistance to high temperatures and resistance to various chemical reactions where the head is relatively large room where temperatures reach the (1000) degrees Maah. Keep the temperature inside the room, burning the secondary under control and constant surveillance by a team work, working CPU final-round full-day no (24) continuous hours and through the control room equipped with the latest technical and scientific technology advanced in terms through which to monitor all the burning of degrees temperature and the proportion of greenhouse gas emissions and the intensification of steam under European laws and regulations relating to the environment and protection of the gases emitted. Where it is sometimes higher temperatures slightly limit allotted under the laws of the environment in force for two seconds (2) only. Spectrum so high room temperature in order to escalate fumes and gases resulting from it, that helps to intensify the additional quantities of steam, which helps to generate energy. 
2 - Department of steam condensation (waste heat boiler for steam generation). 
   In this section of the CPU heat raises the temperature a bit from the usual spectrum to help the rise of gases and vapors from the room burning to the cylinder steam under pressure (41), a bar and a temperature above (350-380) degree Maah, where they are getting (70) tons of condensed steam under pressure (36) in the bar every hour. 
3 - Operations Section washing and cleaning and purification of gases Almenbgth 
(Multi stage flue gas cleaning). As a result of oxidation of hazardous wastes within the rotary kiln and under the stairs high thermal consist of inorganic compounds Gertrh addition to emitting a lot of gases previously mentioned, but the gases must pass through several stages of washing, cleaning and purification, under the laws European on the environment.

إرسال تعليق

أحدث أقدم

نموذج الاتصال